TM-P60 Technical Reference Guide 1. Slide the battery cover to open it. 2. Install the battery. 3. Close the cover. 2.5.3 Charging the battery When you charge the battery, you have a choice of two methods. ❏ Charge the battery using the exclusive battery charger (option: OT-CH60). In this method, remove the empty battery from printer; then put it onto a battery charger. For the battery charger operation, see the user’s manual of the battery charger. This method requires about 2.5 hours to charge the battery. ❏ Charge the battery from the AC adapter (option: PS-10). For this method, turn off the printer. Then connect the AC adapter into the printer’s connector for AC adapter.
(For instructions, see “2.5.5.1 Connecting the AC adapter” (page 2-11).) During the charging, the BATT. LED comes on (color: red). When the charging is completed, the BATT. LED goes off. This method requires about 4 hours to charge the battery.This method also requires the printer’s power to be turned off. If the power is turned on, the battery is not charged; the power is consumed to drive the printer. Rev. C Setup 2-9