TM-P60 Technical Reference Guide FEED Use this button to feed roll paper or to start a roll paper self test, or start printing status sheet. ( See “3.5.1 Self test mode” on page 3-3.) Note: The FEED button can be disabled by using an ESC/POS command. Refer to “ESC/POS Application Programming Guide” for details. 2.1.3 Beeper Function This printer has a “beeper“ function. This function causes beeping in specified situations. The situations are the following:
❏ The remaining battery charge is low (Memory switch can enable/disable this function) ❏ Roll paper is out (Memory switch can enable/disable this function) ❏ A error has occurred except “printer temperature error.“ (Memory switch can enable/ disable this function) ❏ Start of status sheet printing ❏ The printer and host device are not connected (The default setting is for the buzzer not to sound, but it can be set to sound using the memory switch.) Note: About memory switch, see “2.7.3 Memory Switches” (page 2-15). About status sheet, see “3.5.1 Self test mode” (page 3-3). The beeper can be beeped by a command from an application program. See “4.3 Beeper function” (page 4-2) Rev. A Setup 2-3