2.6 Bluetooth Connection The procedures for connecting the host device to the TM-P60 using Bluetooth are indicated below. The TM-P60 uses SSP (Serial Communication Protocol) to create the Bluetooth connection. A Bluetooth-compatible PDA is used as an example for connecting via Bluetooth. In order to print, you must install a PDA printer application on the PDA. 2.6.1 Bluetooth Connection Overview Follow the PDA Bluetooth setup tool instructions for setup operations. One example is indicated below. Use your host device manual for actual operations. PDA Preparation Confirm that your PDA is a Bluetooth-compatible device. Some devices may require installation of a Bluetooth module and software.
Turn printer power on Start the Bluetooth Setup Tool Detect communication-ready Bluetooth devices Select the TM printer from the list of communication-ready devices Enter passkey Confirm the profiles that can be used Setup finished Since the output of Bluetooth radio waves is limited, communication can be affected by the setup location, direction installed, other devices in the area, etc., which may disrupt or decrease the speed of communication. As a result, make sure to thoroughly check device operation prior to using. Establish the Bluetooth connection by using the PDA’s Bluetooth setup tool. Set up the connection by following the direction indicated by this tool. 2-12 Setup Rev. A