Appendix Settings in SimpleAP mode (Factory default settings) Notes on Wireless LAN Connection Because not all the combinations of the printer and wireless LAN devices have been checked for operation, the operation of the printer in combination with all the wireless LAN devices is not guaranteed. Especially in the ad-hoc mode, the printer may not operate normally, depending on the combination of the device to connect with. Be sure to carry out evaluation of the operation before use. Notes on use • When you initialize or change the printer settings, the printer is reset to reflect the settings. It may take about 1 minute depending on the network settings or environment.
Also, your application may indicate power off during the time waiting for reset. In that case, wait for about 1 minute, and then reconnect to the printer. • Where wireless LAN communication is in heavy traffic, your application may falsely recognize that the com- munication is disconnected and indicate power off due to response delay. In that case, disable Power Save to improve the trouble.
Notes on using the roaming function When the roaming function is enabled, if you continue to use the printer in an area where the radio waves for the access point that is connected to are weak, the printer will continue to search for an access point with stron- ger radio waves, thus shortening the battery life. Area with strong radio waves Access point 1 Access point 2 Area with weak radio waves Area unreachable by transmission 87 Parameter Setting value SSID EPSON Printer _ Passphrase 12345678 IP Address 192.168.192.168 Subnet mask 255.255.255.0