Chapter 5 Handling Handling This chapter describes basic handling of the printer. Charging Battery Follow the steps below to charge the battery. You can charge the battery using the printer itself with the AC adapter (PS-11) or using the optional multi-charger (OT-CH60II). Be sure to use the battery OT-BY60II. Using a battery other than the one specified may cause fire, explosion, leakage, overheating or other damage. 5 79 The battery can be charged only when the temperature is 0 ~ 40°C {32 ~ 104°F}. Dispose of used batteries according to the instructions. Do not remove the battery during charging.
Fully charging a battery that is fully discharged while the printer is turned off will take approx- imately 2.5 hours. Charging the battery at 35°C {95°F} or higher may require a longer charging time than the specified one. You can use the printer during the battery charging. For information on the AC adapter (PS-11), see its User’s Manual. For information on the optional multi-charger (OT-CH60II), see its User’s Manual. Using the AC adapter (PS-11) 1 Install the battery. See "Installing the Battery" on page 33. 2 Connect the AC adapter to the connector for the AC adapter. Charging starts. The Charge LED turns on while charging the battery.