Receive Buffer You can set the receive buffer of the TM-T88VI to 4KB or 45 bytes with DIP switch 1-2 as with the TM-T88V. The buffer full condition and buffer full release condition of the TM-T88VI are the same as those of the TM-T88V. The sizes of the download buffer and NV graphics data of the TM-T88VI are the same as those of the TM-T88V. Electrical Characteristics The operating voltage of the TM-T88VI is DC24±7%, the same as the TM-T88V. The current consumption differs, depending on the print duty. When you set the print speed to 350 mm/s, the amount of electricity consumed increases. DIP Switches The functional assignments of DIP switches for the TM-T88VI differ from the TM-T88V.
See "Setting the DIP Switches" on page 53 for more details. Printer Status The TM-T88VI goes to the same status under the same conditions as the TM-T88V. You can replace the TM-T88V with the TM-T88VI without modifying applications. Logo Registration The TM-T88VI can register logos in the NV memory (NVRAM) with the Setup Utilities. You can operate the TM-T88VI with a driver for the TM-T88V. With the TM-T88VI, you can enable the USB low power consumption mode in the software setting mode. 110 Memory Capacity Driver Compatibility USB Low Power Consumption Mode