Appendix Auto Reconnect Feature The auto reconnect feature allows the printer to automatically restore a connection in the following situations if the Bluetooth connection to the iOS device is lost. • When the printer is turned on • When the signal is dropped and then restored The following shows the printer operations and connection methods when the auto reconnect feature is enabled or disabled. * In the following situations, even if the feature is enabled, the same operations are performed as when it is disabled. - When pairing is canceled from the connected iOS device. - When the last Bluetooth device connected was not an iOS device.
- When wireless communication settings are initialized from the printer. * Disable this feature when using the printer from devices that are not running iOS. Otherwise, it may take some time to connect. * For details on the Auto Reconnect Feature, see "Interface Setup Mode" on page 76 . 135 Auto Reconnect Feature Enabled Disabled Printer operations when Bluetooth is disconnected Per form the following reconnection sequence. [Reconnection sequence] 1.The printer tries to connect to the iOS device to which it was last connected. 2.When step 1 fails, the printer waits for connections from other devices.
3.If connection is not established in step 2, the printer tries again to connect to the iOS device to which it last connected. Steps 1 and 2 are repeated until a connection is established. Wait for a connection from the Bluetooth device. Reconnecting to iOS device Reconnect automatically. Make settings on the Bluetooth settings screen on the iOS device. Switch to connection from other device Method 1: After disabling the Bluetooth feature of the connected iOS device, make connection settings on the Bluetooth device that you want to connect. (When the auto reconnect feature is enabled, it may take some time to connect.) Method 2:
After disconnecting from the connected iOS device using applications with the Epson TM Utility for iOS or Epson ePOS SDK disconnection feature, make settings on the Bluetooth device you want to connect.