Appendix Code The hexadecimal numbers corresponding to the XON/XOFF codes are shown below. • XON code: 11H • XOFF code: 13H • When the printer goes from offline to online and the receive buffer is full, XON is not transmitted. • When the printer goes from online to offline and the receive buffer is full, XOFF is not transmitted. • When DIP switch 1-3 is off, XON is not transmitted as long as the printer is offline, even if a receive buffer full state has been cleared. CAUTION compatibility mode, thereby causing half-duplex transmission. 141 IEEE 1284 Parallel Interface Modes The IEEE 1284 parallel interface supports the following two modes.
Mode Communication direction Other information Compatibility mode Host → Printer communication Centronics-compliant Reverse mode Printer → Host communication Assumes a data transfer from an asynchronous printer Compatibility Mode Compatibility mode allows data transmission from host to printer only: Centronics-compatible. Specification Data transmission 8-bit parallel Synchronization Externally supplied STROBE signals Handshaking ACK and BUSY signals Signal levels TTL-compatible connector Connector ADS-B36BLFDR176 (HONDA) or equivalent product Reverse communication Nibble or byte mode Reverse Mode The transfer of status data from the printer to the host proceeds in the nibble or byte mode.
This mode allows data transfer from an asynchronous printer under the control of the host. Data transfers in the nibble mode are made via the existing control lines in units of four bits (a nibble). In the byte mode, data transfer proceeds by making the 8-bit data lines bidirectional.
Both modes fail to proceed concurrently in the Mode Communication direction Other information Compatibility mode Host → Printer communication Centronics-compliant Reverse mode Printer → Host communication Assumes a data transfer from an asynchronous printer Data transmission 8-bit parallel Synchronization Externally supplied STROBE signals Handshaking ACK and BUSY signals Signal levels TTL-compatible connector Connector ADS-B36BLFDR176 (HONDA) or equivalent product Reverse communication Nibble or byte mode