Simple Setup for Wireless LAN This printer comes with a mode (SimpleAP) that allows printers to connect with a smart device or a computer without requiring a wireless access point. This allows you to easily setup a wireless LAN for the printer by using a printer settings tool (Epson TM Utility for iOS/Android or EpsonNet Config) even without a network environment such as access points. SimpleAP mode is enabled by default when shipping from the factory. When SimpleAP mode is enabled and the printer is turned on, the following information is printed automatically. SimpleAP Start SSID Encryption Type Passphrase : EPSON_Printer : WPA-2-PSK : 12345678 IP Address MAC Address : 192.168.192.168 :
xx-xx-xx-xx-xx-xx Although operations are performed in SimpleAP mode during the initial startup, operations switch to standard mode (infrastructure mode) when changing settings in Epson TM-T88VI Utility for Windows or EpsonNet Config. After switching, operations continue in standard mode. If you want to make settings in SimpleAP mode again, initialize the communication settings (see "Resetting the Interface Settings" on page 84 ). Changing to standard mode Ex.) Change IP address, change SSID SimpleAP mode (default setting) Standard mode (infrastructure mode) Initialize the communication settings * You can also set this to standard mode (Ad-Hoc mode) except for the OT-WL06. 26