Chapter 3 Advanced Usage Customize Value Settings Modes 0: Exit 1: Print Current Settings 2: Print Density 3: Print Speed 4: Automatic Paper Reduction 5: Auto Paper Feed&Cut at cover close 6: Paper Width 7: Top Margin 8: Character/Font Settings 9: Interface Selection 10: Interface Settings 11: Command Execution (Offline) 12: Power Supply Output 13: Other Settings Select Modes by executing following procedure. step 1. Press the Feed button less than 1 second as many times as the selected mode number. step 2. Press Feed button for 1 second or more.
3 3 After briefly pressing the Feed button (less than one second) for the number of times shown in the print result, hold down the button for more than one second to select the setting items. The setting selected as the setting item, the current settings and default settings are printed. Depending on the setting item, you may need to continue selecting the setting item before the settings are printed. For details on setting items, see "Software Settings" on page 59 . When set to a value other than those in the software setting mode, the current settings are not printed.
4 Select a setting by briefly pressing the Feed button (less than one second) for the number of times applicable to the setting, and then hold down the button for more than one second to confirm your selection. After saving the settings, the Software setting mode guidance is printed, and the Paper LED flashes. 5 To close Software setting mode, turn off the printer, or select “Exit” to return to Mode selection guidance, and then select “Exit and Reboot Printer”. • To select 0 as the item number, hold down the Feed button until printing starts. • If the button is pressed a number of times that is not displayed by the Setup guidance, the operation is invalid and the same guidance is printed. 73