Connecting the Power Supply Unit (PS-180) Use the PS-180 or an equivalent product as the power supply unit. Always use the Epson PS-180 or an equivalent product as the power supply unit. Using a nonstandard power supply can result in electric shock and fire. Should a fault ever occur in the Epson PS-180 or equivalent product, immediately turn off the power to the printer and remove the power supply cable from the wall socket. WARNING Connecting the Power Supply Unit 1 Make sure the printer’s power supply is turned off and the power supply unit’s power cable has been removed from the wall socket.
2 Insert the connector of the power supply cable onto the power supply connector (stamped 24V ). Be sure to remove the power supply unit’s cable from the wall socket whenever connecting or disconnecting the power supply unit to the printer. Failure to do so may result in damage to the power supply unit or the printer. Make sure the wall socket power supply satisfies the rated voltage requirements of the power supply unit. Never insert the power supply cable plug into a socket that does not meet the rated voltage requirements of the power supply unit. Doing so may result in damage to both the power supply and the printer.
WARNING Before removing the DC cable connector from the PS-180, make sure the power supply cable has been removed from the power supply unit, then grasp the arrow-marked section of the connector and pull straight out. 34