2. PRINTER SETUP ENGLISH VERSION EO1-33094 2.3 Loading Supplies 2.3.1 Loading the Media The following procedure shows the steps to properly load the media into the printer so that it feeds straight through the printer. The printer prints both labels and tags. 1. Open the Top Cover. 2. Turn the Head Lever to the FREE position and release the Ribbon Shaft Holder Plate or Drive Holder Plate. 3. Open the Print Head Block. 4. Move the Paper guide R to the rightmost position or shift the guide to the horizontal position. NOTES: 1. When the Head Lever is turned to FREE position, the Print Head can be raised. 2. To enable printing the Head Lever must be set to the LABEL / TAG position.
(This ensures that the Print Head is closed.) There are two head pressure levels in the LABEL / TAG position. Set the Head Lever depending on the media type: Position LABEL : Labels Position TAG : Tags However, proper position may differ depending on media. For details, refer to your TOSHIBA TEC authorised service representative. Top Cover Print Head Block FREE TAG LABEL Head Lever Ribbon Shaft Holder Plate For D2 model, Drive Holder Plate Paper Guide L Paper Guide R 5. Put the media on the Paper Holder. 6. Pass the media around the Paper Holder, and then pull the media towards the front of the printer. 7. Push the Paper Guide against the media until the media is held firmly in place.
To lock the Media, shift the Paper Guide R to vertical position E2- 5