cisco — Verifying the Provisioning of an EVPN VXLAN Layer 3 Overlay Network

To troubleshoot unicast forwarding between two VTEPs in different VLANs using a Layer 3 VNI, follow these steps: • Verify the provisioning of the EVPN VXLAN Layer 3 overlay network. • Verify inter-subnet traffic movement and symmetric IRB in the EVPN VXLAN Layer 3 overlay network. Verifying the Provisioning of an EVPN VXLAN Layer 3 Overlay Network To verify the provisioning of an EVPN VXLAN Layer 3 overlay network, perform these checks: 1. Verify that the Access SVIs, Core SVIs, and NVE Interfaces are Up, on page 19 2. Verify that the IP VRF is Provisioned with the Correct SVIs, Stitching Route-Targets, and Route Distinguisher, on page 20 3.

Verify that Both Layer 2 and Layer 3 VNIs are provisioned in the VRF and are UP, on page 21 4. Verify that EVPN Manager is Updated from the NVE with all the Layer 2 and IRB Attributes, on page 22 5. Verify that the Remote Layer 3 VNI Details are Learned on Each VTEP, on page 23 6. Verify that the Layer 3 VNI Tunnel Pseudoport is Installed into Layer 2 FIB in the Core VLAN, on page 23 Verify that the Access SVIs, Core SVIs, and NVE Interfaces are Up The following examples show how to verify that the access SVIs, core SVIs, and NVE interfaces are up: VTEP-1# show ip interface brief Interface IP-Address OK?

Method Status Protocol Vlan10 10.10.10.1 YES NVRAM up up Vlan12 10.12.12.1 YES NVRAM up up Access Interface Vlan99 10.255.1.1 YES unset up up Core Interface If protocol status for the core interface is down, run the no autostate command Loopback0 10.1.1.1 YES NVRAM up up Loopback999 10.255.1.1 YES NVRAM up up Tunnel0 10.255.1.1 YES unset up up Troubleshooting BGP EVPN VXLAN Verifying the Provisioning of an EVPN VXLAN Layer 3 Overlay Network Check to be Performed Steps to Follow Do you have an SVI interface configured for the remote subnet? Run the show ip interface brief | excluse unassigned command in privileged EXEC mode on the VTEP.

Do you have the EVPN instance configured on your local VTEP? Run the following commands in privileged EXEC mode on the VTEP: • show run | section l2vpn • show run | section vlan config • show run interface nve interface-number Troubleshooting BGP EVPN VXLAN 19