Tutorials Fig. 17: Figure 2: Wizard Dialog when successfully returned to the original mode The wizard can now be closed via the "Finish" button. 4.7 Creating simulation template project Creating and adding a new simulation PLC is done via selection and activating the Contextmenu entry "Create Simulation PLC-Project" of the PLC runtime that is intended to be simulated in the configuration navigation tree (see Figure 1). Within the now appearing Dialog, the Simulation PLC runtime must be selected (Figure 2). This dialog shows the currently available target systems. If the designated simulation system is not in the tree, it can be added via the "Search" button.
With leaving the dialog over "OK" the TwinCAT Simulation Manager generates a simulation framework for the selected PLC, assigns it to the specified target system and runtime and adds it to the TwinCAT Simulation Manager configuration project. This PLC framework project will contain all located IO-Symbols of the original PLC project in reversed/ mirrored allocation (inputs --> outputs and outputs --> inputs, see Table 1). TS1110 31 Version: 1.0