beckhoff TS1110 — 5.3.4 Dialog 'Manage target systems'

User interface Fig. 49: Figure 2: Context menu of the Dialog 'Broadcast search' Table 2: Context menu of the Dialog 'Broadcast search' 5.3.4 Dialog 'Manage target systems' The dialog 'Manage target systems' is used to manage the target systems within the actual TwinCAT Simulation Manager project. TS1110 54 Version: 1.0 Menu entry Description Refresh Sends an immediate broadcast search message and aktualizes the list of target systems. Ping Pings the target system with a UDP-message. If the target is connected to the same subnet and is running, the Ping will succeed. AdsPing Pings the target system via ADS.

In addition that the target is reachable via UDP, both systems must run a TwinCAT environment (in 'Run' or 'Config' mode) and both systems must refer each other via ADS Routes. This Context Menu Item is only active when the target system is assigned as local route. Show target routes ... Show the routes that are registered at the selected target (only if the target route is assigned to the local system) Add route ... dds the selected target system as (remote) route to the local system (and vice versa). Remove route ... Removes the selected target system from the local system (and vice versa). Properties ... Shows the properties of the selected target system.