beckhoff TX1000 — 2 Installation

Installation 2 Installation Installing TwinCAT Please refer to the appropriate TwinCAT documentation for details of its installation Installing the SST Programs The installation versions of the SST device driver for the 5136-CN PC card (DeviceDriver directory) and of the SST configuration tool (ConfigTool directory) are located in the Unsupported Utilities/Sst directory. Use the following procedure for installation: Installing the SST Device Driver Run the setup program from the Unsupported Utilities/Sst/DeviceDriver directory, and follow the instructions given by the program.

Installing the SST Configuration Tool Run the setup program from the Unsupported Utilities/Sst/ConfigTool directory, and follow the instructions given by the program. Performing the 5136-CN Hardware Settings ( not necessary for the 5136-CN PCI ) Run the SST Card Configuration program, found under Programs->SST Card Config. Normally a window will appear with two default entries: One entry should be deleted (using the Remove button), and the other should be edited (using Properties). A new dialog appears in which the I/O address of the 5136-CN is to be set in accordance with the DIP switch and where the memory address and the name can be adjusted. TX1000 8 Version: 1.0