PLC libraries VAR_INPUT VAR_INPUT sIPAddr : STRING(15); nTCPPort : UINT:= MODBUS_TCP_PORT; nUnitID : BYTE:=16#FF; nQuantity : WORD; nMBAddr : WORD; cbLength : UDINT; pSrcAddr : UDINT; bExecute : BOOL; tTimeout : TIME; END_VAR sIPAddr : Is a string containing the IP address of the target device. nTCPPort : Port number of the target device. nUnitID : Identification number of a serial sub-network device. If a device is addressed directly via TCP/IP, this value must be 16#FF. nQuantity : Number of digital outputs to be written (data bits). nQuantity must be > 0. nMBAddr: Start address of the digital outputs to be written (bit offset). cbLength : Contains the max.
byte size of the source buffer containing the data to be written. The minimum buffer byte size must be: (nQuantity + 7) / 8 . pSrcAddr : Contains the address of the source buffer containing the data to be written. The buffer can be a single variable, an array or a structure, whose address can be found with the ADR operator. bExecute : The function block is activated by a rising edge at this input. tTimeout : States the length of the timeout that may not be exceeded by execution of the ADS command. VAR_OUTPUT VAR_OUTPUT bBUSY : BOOL; bError : BOOL; nErrId : UDINT; END_VAR bBusy : When the function block is activated this output is set. It remains set until an acknowledgement is received.
bError : If an ADS error should occur during the transfer of the command, then this output is set once the bBusy output is reset. nErrId : Supplies the ADS error number when the bError output is set. Example of calling the block in FBD: PROGRAM Test VAR fbWriteCoils : FB_MBWriteCoils; bWriteCoils : BOOL; bWriteCoilsBusy : BOOL; bWriteCoilsError : BOOL; nWriteCoilsErrorId : UDINT; nWriteCoilsCount : UDINT; nQuantity : WORD := 10; TS6250 30 Version: 1.2 Function specific ADS error code Possible reason 0x8001 Modbus function not implemented 0x8002 Invalid address or length 0x8003 Invalid parameters: - wrong number of registers 0x8004 Modbus server error