beckhoff TE1000 TwinCAT 3 Multiuser — 2 Installation

Installation 2 Installation As of TwinCAT 3.1 Build 4026 the installation of TwinCAT Multiuser is required. All earlier versions of TwinCAT 3 include TwinCAT Multiuser as part of the standard installation. TwinCAT Multiuser is installed via the TwinCAT Package Manager. Further information on this can be found in the installation documentation . You can perform the installation using either the user interface (UI) or the command line interface (CLI). You can use the UI to display all available workloads and install them as needed. To do this, follow the corresponding instructions in the interface. You can use the following command to display the available workloads on the system in the CLI:

tcpkg list -t workload Explanations on installation via CLI can be found in the chapter Working with the command line . When referring to the TwinCAT Multiuser installation in the following, a distinction is made between PCs with TwinCAT Engineering and systems with TwinCAT Runtime only. On a PC with Engineering or with Engineering and Runtime If TwinCAT Engineering and TwinCAT Runtime or only TwinCAT Engineering are installed on your system, install both Multiuser Editor and Multiuser Server. To do this, choose the following two workloads in the TwinCAT Package Manager UI:

TwinCAT Multiuser - Engineering TwinCAT Multiuser – Runtime Or install the workloads via the CLI using the following commands: tcpkg install TwinCAT.Multiuser.XAE tcpkg install TwinCAT.Multiuser.XAR Multiuser Editor and Multiuser Server are installed. TE1000 8 Version: 1.7.1