Overview of NC errors 2.8 Table Errors TwinCAT 43 Version: 1.1 Error(Hex) Error(Dec) Error type Description 4A00 18944 parameter "Table ID not allowed" The value for the table ID is not allowed, e.g. because it has already been assigned, is less than or equal to zero, or is greater than 255. Value range: [1 ... 255] Unit: 1 4A01 18945 parameter "Table type not allowed" The value for the table type is unacceptable because it is not defined. Value range: [1 ] Unit:
1 4A02 18946 parameter "Number of lines in the table not allowed" The value of the number of lines in the table is not allowed, because, for example, it is smaller than two at linear interpolation and smaller than four at spline interpolation. Value range: [2, 0xFFFF] Unit: 1 4A03 18947 parameter "Number of columns in the table is not allowed" The value of the number of columns in the table is not allowed, because, for example, it is less than or equal to zero (depends upon the type of table or slave). Value range: [1, 0xFFFF] Unit:
1 4A04 18948 parameter "Step size (position delta) not allowed" The value for the step size between two lines (position delta) is not allowed, because, for example, it is less than or equal to zero. Value range: [0.001, 1.0E+6] Unit: e.g. mm 4A05 18949 parameter "Period not allowed" The value for the period is not allowed, because, for example, it is less than or equal to zero. Value range: [0.001, 1.0E+9] Unit: e.g. mm 4A06 18950 parameter "Table is not monotonic" The value for the step size is not allowed, because, for example, it is less than or equal to zero.
4A07 18951 initialization „Table sub type is not allowed“ The value for the table sub type is not allowed or otherwise the table class (slave type) do not match up to the table main type. Table sub type: (1) equidistant linear position table, (2) equidistant cyclic position table, (3) none equidistant linear position table, (4) none equidistant cyclic position table Value range: [1, 4] Unit: 1 4A08 18952 initialization „Table interpolation type is not allowed“ The value for the table interpolation type is allowed. Table interpolation type: (0) linear-interpolation, (1) 4-point-interpolation, (2) spline-interpolation Value range: [0, 2] Unit:
1 4A09 18953 initialization "Incorrect table main type" The table main type is unknown or otherwise the table class (slave type) do not match up to the table main type. Table main type: (1) camming table, (2) characteristic table, (3) 'motion function' table (MF) 4A10 18960 initialization "Table initialization" Table has not been initialized. Although the table has been created, the rest of the initialization has not been performed. For instance, the number of lines or columns may be less than or equal to zero. 4A11 18961 initialization "Not enough memory" Table could not be created, since there is not enough memory.