TwinCAT PLC Library Hydraulics - Version 1.4 — 5.7.7 Reference velocity/velocity ratio

Knowledge Base Vref:= Qn*1.000.000/60/ A The LinDef tab can be used to implement various settings. Further information can be found here. If this is activated, the AutoIdent function block starts by first determining the travel limits. The axis is then positioned at a distance of at least 10 % from the travel limits, in order to determine the overlap. Once this has been carried out successfully, the axis moves to the lower end and starts measuring. Depending on the available travel distance, several measurements are carried out in each direction. Once the characteristic curve has been successfully measured, it can be viewed in the LinTab tab.

A successfully measured characteristic curve can be recognized by the fact that stParams.bLinTabAvaiable is TRUE. The chapter Coverage and reference velocity should be skipped if the characteristic curve was measured successfully. 5.7.6 Overlap In order to determine the overlap, the set velocity must be increased slowly until a response by the actual velocity can be recognized. It is possible that the set velocity must be increased to a value of up to 30 mm/s before a response of the actual velocity can be seen. When measuring the overlap, the overlap itself should always be set to zero.

If different velocity set values are required in order to move the axis in positive or negative direction from standstill, this indicates an asymmetric valve. In this case the check mark Asym in the Global tab must be set and activated. The valve can now be parameterized separately in positive and negative direction. The set velocity at which the axis moves must be entered under Overlap in the "Valve" tab. If the overlap has already been assigned a value, this value must be taken into account.

For asymmetric valves ensure that the entry is made in the correct field; the overlap for the positive direction is expected in the upper field, the overlap for the negative direction in the lower field. After this optimization the axis should also respond at different small velocities. Whether the axis responds with the right velocity is not important. If an overlap has been entered from the data sheet and the axis always moves too fast, the overlap should be reduced. 5.7.7 Reference velocity/velocity ratio NOTE! This chapter describes manual commissioning. A characteristic curve measurement also determines the parameters discussed here. If it is used, this chapter should be skipped.

Once the axis can be moved at low velocity, the reference velocity must be set. In order to determine the reference velocity, the set velocity is increased step-by-step, and a check is carried out to determine whether the axis follows with approximately the set velocity. NOTE! In this step, only movements in the faster direction are to be evaluated. The oil is transported into the small piston surface! The next step deals with directional dependency. To trigger the required movements, the position and velocity can be specified in the Status tab. The movement is executed with the Start button. The previously created Scope View should be used to analyze the velocities. NOTE!

The software limit switches should be activated and set so that the axis does not hit the mechanical limit stops. PLC Library Hydraulics 263 Version: 1.4