Beckhoff Automation GmbH & Co. KG TX1200 — 5.8 Continuous Function Chart Editor (CFC)

Editors x should initialized to 1 and y initialized to 0. The numbers in the right corner of the block indicate the order in which the commands are executed. x will be increased by one until it reaches the value 10. This causes the output of the block LT(0) to deliver the value FALSE and SUB(3) and ADD(5) will be executed. x is set back to the value 1 and y is increased by 1. LT(0) is executed again as long as x is smaller than 10. y thus count the number of times x passes though the value range 1 to 10. 'Extras' 'Properties...' Constant input parameters (VAR_INPUT CONSTANT) from functions and function blocks are not shown directly in the continuous function chart editor.

These can be shown and their value can be changed when one selects the trunk of the block in question (Cursor position 1) and then selects the command ‚Extras' ‚Properties' or simply double clicks on the trunk. The dialog edit parameter opens: The values of the constant input parameter (VAR_INPUT CONSTANT) can be changed. Here it is necessary to mark the parameter value in the column Value. Another mouse click or pressing on the space bar allows this to be edited. Confirmation of the change to the value is made by pressing the key or pressing rejects the changes. The button OK stores all of the changes which were made.

Selecting Elements One clicks on the trunk of the element (Cursor position 1) to select it. To mark more elements one presses the key and clicks in the elements required, one after the other, or one drags the mouse with the left hand mousekey depressed over the elements to be marked. The command 'Extras' 'Select all' marks all elements at once. Moving elements TX1200 145 Version: 1.3