Visualization Modifying Visualization Elements You can select an element which has already been inserted by a mouse click on the element or by pressing the key. A small black square will appear at each corner of each of the elements, (with ellipses at the corners of the surrounding rectangle). Except in the case of polygons, lines or curves further squares appear in the middle of the element edges between the corner points. With a selected element, the turning point (balance point) is also displayed at the same time. You can then rotate the element around this point with a set motion/angle. The turning point is displayed as a small black circle with a white cross ( ).
You can drag the turning point with a pressed left mouse button. You can change the size of the element by clicking on one of the black squares and, while keeping the left mouse button pressed, controlling the new outline. With the selection of a polygon, you can drag each individual corner using the same technique. While doing this, if you press the -key then an additional corner point will be inserted at the corner point, an additional corner point will be inserted, which can be dragged by moving the mouse. By pressing the + -key, you can remove a corner point. Dragging Visualization Elements One or more selected elements can be dragged by pressing the left mouse button or the arrow key.
Grouping Elements Elements can be grouped by selecting all desired elements and performing the command 'Extras' 'Group'. The group will behave like a single element: the grouped elements get a collective frame; when dragging the frame all elements will be stretched or compressed; only the group can be moved to another position. the grouped elements get collective properties: inputs only can effect the group and not a single element. Thus the elements also get one collective configuration dialog (category 'group'). The property 'Change color' can not be configured for a group ! To redefine a single element of a group, the grouping must be redone by the command 'Extras' 'Break up group'.
The configuration of the group will be lost in this case. . 'Extras' 'Send to Front' Use this command to bring selected visualization elements to the front. 'Extras' 'Send to Back' Use this command to send selected visualization elements to the back. 'Extras' 'Align' Use this command to align selected visualization elements. The following alignment options are available: Left : the left edge of each of the elements will be aligned to the element that is furthest to the left the same is true for Right / Top / Bottom Horizontal Center : each of the elements will be aligned to the average horizontal center of all elements Vertical Center :
each of the elements will be aligned to the average vertical center of all elements TX1200 264 Version: 1.3