Appendix 11.2 Command Line/Command File Commands Command Line Commands When TwinCAT PLC Control is started, you can add commands in the command line which will be asserted during execution of the program. These commands start with a "/". Capitalization/Use of small letters is not regarded. The commands will be executed sequentially from the left to the right. TX1200 334 Version:
1.3 CFC Editor Commands 'Insert''POU' + 'Insert''Input' + 'Insert''Output' + 'Insert''Jump' + 'Insert''Label' + 'Insert''Return' + 'Insert''Comment' + 'Insert''POU input' + 'Extras''Negate' + 'Extras''Set/Reset' + 'Extras''Connections' + 'Extras''EN/ENO' + 'Extras''Zoom' + LD Editor Commands 'Insert''Network (after)' + 'Insert''Contact' + 'Insert''Parallel Contact' + 'Insert' 'Function Block' + 'Insert''Coil' + 'Extras''Paste Below' + 'Extras''Negate' + SFC Editor Commands 'Insert''Step-Transition (before)' + 'Insert''Step-Transition (after)' + 'Insert''Alternativ Branch (right)' + 'Insert''Paralell Branch (right)' + 'Insert''Jump' (AS) + 'Extras''Zoom Action/Transition' + Move back to the editor from the SFC Overview Work with the PLC Configuration Open and close organization elements Place an edit control box around the name ‘Extras’ ‘Edit Entry’ Work with the Task configuration Place an edit control box around the task or program name