Individual Components %QB24 is written to at the following locations: PLC_PRG (3): %QB24 PLC_PRG.POU1 (8): %QB24 Results are displayed in the message window. User groups In TwinCAT PLC Control up to eight user groups with different access rights to the POUs, data types, and ressources can be set up. Access rights for single objects or all of them can be established. Only a member of a certain user group can open a project. A member of such a user group must identify himself by means of a password. The user groups are numbered from 0 to 7, whereby the Group 0 has the administrator rights, i.e. only members of group 0 may determine passwords and access rights for all groups and/or objects.
When a new project is launched, then all passwords are initially empty. Until a password has been set for the 0 group, one enters the project automatically as a member of the 0 group. If a password for the user group 0 is existing while the project is loaded, then a password will be demanded for all groups when the project is opened. For this the following dialog box appears: Dialog box for password entry In the combobox User group on the left side of the dialog box, enter the group to which you belong and enter on the right side the relevant password. Press OK . If the password does not agree with the saved password, then the message appears:
"The password is not correct." Only when you have entered the correct password can the project be opened. If passwords are not assigned for all user groups, it is possible to open a project via a user group for which none has been assigned! With the command 'Passwords for user group' you can assign passwords, with the command 'Object' 'Access rights' the rights for individual or all objects. 'Project' 'Passwords for user groups' This command opens the password assignment dialog for user groups. This command can be executed only by members of group 0. When the command is executed, the following dialog opens:
Dialog for password assignment In the left User Group combo box you can select the group. Enter the desired password in the Password field for this group. An asterisk (*) appears in the field for each typed letter. You must repeat the same word in the Confirm Password field. Close the dialog with OK after each password entry. If the message comes:" The password and its confirmation do not match."you have mistyped one of the two entries. Therefore, it is best TX1200 86 Version: 1.3