PMAC Product Guide Timers Timing commands like DWELL or DELAY are reserved only for motion programs and cannot be used for timing purposes on PLCs. Instead, PMAC has four 24-bit timers that you can write to and count down once per servo cycle. These timers are at registers X:$0700, Y:$0700, X:$0701, and Y:$0701. Usually a signed M-Variable is assigned to the timer; a value is written to it representing the desired time in servo cycles (multiply milliseconds by 8,388,608/I10); then the PLC waits until the M-Variable is less than 0. Example:
M90->X:$0700,0,24,S ; Timer register 1 (8388608/I10 msec) M91->Y:$0700,0,24,S ; Timer register 2 (8388608/I10 msec) M92->X:$0701,0,24,S ; Timer register 3 (8388608/I10 msec) M93->Y:$0701,0,24,S ; Timer register 4 (8388608/I10 msec) OPEN PLC3 CLEAR M1=0 ; Reset Output1 before start M90=1000*8388608/I10 ; Set timer to 1000 msec, 1 second WHILE (M90>0) ; Loop until counts to zero ENDWHILE M1=1 ; Set Output 1 after time elapsed DIS PLC3 ; disables PLC3 execution (needed in this example) CLOSE If more timers are needed, use memory address X:0. This 24-bit register counts up once per servo cycle.
Store a starting value for this, and then at each scan, subtract the starting value from the current value and compare the difference to the amount of time to wait. Example: M0->X:$0,24 ; Servo counter register M85->X:$07F0,24 ; Free 24-bit register M86->X:$07F1,24 ; Free 24-bit register OPEN PLC 3 CLEAR M1=0 ; Reset Output1 before start M85=M0 ; Initialize timer M86=0 WHILE(M86 ; Time elapsed less than specified time?
M86=M0-M85 M86=M86*I10/8388608 ; Time elapsed so far in milliseconds ENDWHILE M1=1 ; Set Output 1 after time elapsed DISABLEPLC3 ; disables PLC3 execution (needed in this example) CLOSE Even if the servo cycle counter rollovers (start from zero again after the counter is saturated), by subtracting into another 24-bit register, rollover is handled gracefully. Rollover example: M0 = 1000 M85 = 16777000 M86 = 1216 Carry-out bit PLC Programs 89 Bit 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 M0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 0 1 0 0 0 M85 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 0 0 1 0 1 0 0 0 M86 0 0 0 0 0 0 0 0 0 0 0 0 0 1 0 0 1 1 0 0 0 0 0 0