PMAC Product Guide I-VARIABLES On PMAC, I-Variables (Initialization, or Set-up, Variables) determine the personality of the controller for a given application. They are at fixed locations in memory and have pre-defined meanings. Most are integer values and their range varies depending on the particular variable. There are 1024 I-Variables, from I0 to I1023, and they are organized as follows: I0 -- I75: General card setup (global) I76 -- I99: Dual-speed resolver setup I100 -- I186: Motor #1 setup I187 -- I199: Coordinate System 1 setup I200 -- I286: Motor #2 setup I287 -- I299: Coordinate System 2 setup ... I800 -- I886: Motor #8 setup I887 -- I899: Coordinate System 8 setup I900 -- I979:
Encoder 1 - 16 setup (in groups of 5) I980 -- I1023: Reserved for future use In this section, some I-Variables might be expressed as Ix00. In the case of a motor I-Variable, x stands for the motor number in the range of 1 through 8. In the case of a Coordinate System I-Variable, x stands for the coordinate system number, also in the range of 1 through 8. The PMAC motion controller is rich in features and expansion capabilities. Because this manual illustrates the implementation of PMAC in a typical application, some of the PMAC advanced I-Variables are not described. Further information of all the PMAC I-Variables can be obtained from the PMAC Software Reference manual. Note:
Global I-Variables I1 Serial Port Mode Range: 0 .. 3 Default: 0 Units: none This parameter controls two aspects of how PMAC uses its serial port. The first aspect is whether PMAC uses the CS (CTS) handshake line to decide if it can send a character out the serial port. The second aspect is whether PMAC will require software card addressing, permitting multiple cards to be daisychained on a single serial line. There are four possible values of I1, covering all the possible combinations: When CS handshaking is used (I1 is 0 or 2), PMAC waits for CS to go true before it will send a character.
This is the normal setting for real serial communications to a host; it allows the host to hold off PMAC messages until it is ready. I-Variables 97 Setting Meaning 0 CS handshake used; no software card address required 1 CS handshake not used; no software card address required 2 CS handshake used; software card address required 3 CS handshake not used; software card address required