PMAC Product Guide FRAX Function : Specify the coordinate system's feedrate axes. Scope : Coordinate-system specific Syntax : FRAX FRAX({axis}[,{axis}...]) where {axis} (optional) is a character (X, Y, Z, A, B, C, U, V, W) specifying which axis is to be used in the vector feedrate calculations This command specifies which axes are to be involved in the vector-feedrate (velocity) calculations for upcoming feedrate-specified ( F ) moves. PMAC calculates the time for these moves as the vector distance (square root of the sum of the squares of the axis distances) of all the feedrate axes divided by the feedrate.
Any non-feedrate axes commanded on the same line will complete in the same amount of time, moving at whatever speed is necessary to cover the distance in that time. Vector feedrate has obvious geometrical meaning only in a Cartesian system for which it results in constant tool speed regardless of direction, but it is possible to specify for non-Cartesian systems and for more than three axes.
If only non-feedrate axes are commanded to move in a feedrate-specified move, PMAC will compute the vector distance, and therefore the move time, as zero and will attempt to do the move in the acceleration time (TA or 2*TS), possibly limited by the maximum velocity and/or acceleration parameters for the motors. This will probably be much faster than intended. If a motion program buffer is open when this command is sent to PMAC, it will be entered into the buffer for later execution. For instance, in a Cartesian XYZ system, if using FRAX(X,Y) , all of the feedrate-specified moves will be at the specified vector feedrate in the XY-plane, but not necessarily in XYZ-space.
If using FRAX(X,Y,Z) or FRAX , the feedrate-specified moves will be at the specified vector feedrate in XYZ- space. Default feedrate axes for a coordinate system are X, Y, and Z. Examples: FRAX ; Make all axes feedrate axes FRAX(X,Y) ; Make X and Y axes only the feedrate axes FRAX(X,Y,Z) ; Make X, Y, and Z axes only the feedrate axes H Function : Perform a feedhold Scope : Coordinate-system specific Syntax : H This causes the currently addressed coordinate system to suspend execution of the program starting immediately by bringing its time base value to zero, decelerating along its path at a rate defined by the coordinate system I-variable Ix95.
Technically the program is still executing after an H command, but at zero speed. This means that the motors defined in the coordinate system cannot be moved while performing the feed hold. To perform a hold of the currently addressed coordinate system in a manner that permits jogging of the motors in the coordinate system while in feed hold mode, refer to the \ program hold command. The H command is similar in effect to a %0 command, except that deceleration is controlled by Ix95, not Ix94, and execution can be resumed with an R or an S command, instead of a %100 command. In addition, H works under external time base, whereas a %0 command does not. 162 Online Commands