omron — LINEAR

PMAC Product Guide In circular moves, this specifies the component of the vector to the arc center that is parallel to the Y-axis. The starting point of the vector is either the move start point (for INC (R) mode -- default) or the XYZ- origin (for ABS (R) mode). In a NORMAL command, this specifies the component of the normal vector to the plane of circular interpolation and tool radius compensation that is parallel to the Y-axis. Examples: X10 Y20 I5 J5 Y(2*P1) J(P1) J33.333 specifies a full circle whose center is 33.333 units in the positive Y-direction from the start and end point NORMAL J-1 specifies a vector normal to the ZX plane K{data} Function :

K-vector specification for circular moves Type : Motion program (PROG and ROT) Syntax : K{data} where {data} is a floating-point constant or expression representing the magnitude of the K-component of the vector in scaled user axis units. In circular moves, this specifies the component of the vector to the arc center that is parallel to the Z-axis. The starting point of the vector is either the move start point (for INC (R) mode -- default) or the XYZ- origin (for ABS (R) mode). In a NORMAL command, this specifies the component of the normal vector to the plane of circular interpolation and tool radius compensation that is parallel to the Y-axis. Examples:

X10 Z20 I5 K5 Z(2*P1) K(P1) K33.333 specifies a full circle whose center is 33.333 units in the positive Z-direction from the start and end point NORMAL K-1 specifies a vector normal to the XY plane LINEAR Function : Blended linear interpolation move mode Type : Motion program (PROG and ROT) Syntax : LINEAR LIN The LINEAR command puts the program in blended linear move mode (this is the default condition on power-up/reset). Subsequent move commands in the program will be processed according to the rules of this mode. On each axis, the card attempts to reach a constant velocity that is determined by the most recent feedrate ( F ) or move time ( TM ) command.

The LINEAR command takes the program out of any of the other move modes ( CIRCLE , PVT , RAPID , SPLINE ). A command for any of these other move modes takes the program out of LINEAR mode. Examples: LINEAR ABS CIRCLE1 X10 Y20 I5 LINEAR X10 Y0 OPEN PROG 1000 CLEAR N1000 LINEAR RETURN Buffer Commands 223