PMAC Product Guide This matrix must have been created already with the on-line DEFINE TBUF command. That command specifies the number of matrices to create, and it must have specified a number at least as high as the number used in TSEL (a matrix cannot be selected that has not been created). TSEL0 deselects all transformation matrices, saving calculation time. Examples: DEFINE TBUF 5 ; Create 5 transformation matrices OPEN PROG 10 CLEAR ... TSEL 3 ; Select transformation matrix 3 (of 5) TINIT ; Make matrix 3 the identity matrix U{data} Function : U-axis move Type : Motion program Syntax :
U{data} where {data} is a floating point constant or expression representing the position or distance in user units for the U-axis. This command causes a move of the U-axis. (See {axis}{data} description in this section.) Examples: U10 U(P17+2.345) X20 U20 U(COS(Q10)) V(SIN(Q10)) V{data} Function : V-axis move Type : Motion program (PROG and ROT) Syntax : V{data} where {data} is a floating point constant or expression representing the position or distance in user units for the V-axis. This command causes a move of the V-axis. (See {axis}{data} description in this section.) Examples: V20 U56.5 V(P320) Y10 V10 V(SQRT(Q20*Q20+Q21*Q21)) W{data} Function : W-axis move Type :
Motion program Syntax : W{data} where {data} is a floating point constant or expression representing the position or distance in user units for the W-axis. This command causes a move of the W-axis. (See {axis}{data} description in this section.) 240 Buffer Commands