User Manual of EM730 Series Inverter This mode is mainly used when the motor cannot rotate. Static self-learning has poorer effects than rotary self-learning. F01.34=2 : the asynchronous motor rotates during parameter self-identification. Prior to the rotary self-learning of the asynchronous motor, please set the motor type (F01.00) and motor nameplate parameters (F01.01 to F01.08) correctly. Relevant parameters (F01.09 to F01.18) of the asynchronous motor can be obtained during rotary self-learning. minimized; otherwise, self-learning will have poor effects. This mode is mainly used when the motor can rotate. However, loads should be avoided or F01.34=11 :
the synchronous motor remains stationary during parameter self-identification. Prior to the static self-learning of the synchronous motor, please set the motor type (F01.00) and motor nameplate parameters (F01.01 to F01.05) correctly. Relevant parameters (F01.19 to F01.21) of the synchronous motor and current loop parameters (F06.12 to F06.15) can be obtained during static self-learning. This mode is mainly used when the motor cannot rotate. It is necessary to manually enter the counter electromotive force (F01.22). F01.34=12 : the synchronous motor rotates during parameter self-identification.
Prior to the rotary self-learning of the synchronous motor, please set the motor type (F01.00) and motor nameplate parameters (F01.01 to F01.05) correctly. Relevant parameters (F01.19 to F01.21) of the synchronous motor, current loop parameters (F06.12 to F06.15) and counter electromotive force (F01.22) can be obtained during rotary self-learning. This mode is mainly used when the motor can rotate. However, loads should be avoided or minimized; otherwise, self-learning will have poor effects. 1. Motor parameter self-learning is valid only in the keyboard-controlled start/stop mode (F00.02=0):
Set F01.34 to the corresponding value, and press the ENTER key to start motor parameter self-learning. After the parameter self-learning, F01.34 of the inverter will be automatically set to 0; 2. If there is an overcurrent or overvoltage protection during self-learning, extend the acceleration & deceleration time and try again. 3. The first group of motor parameters is taken as an example above. For the second group of motor parameters, refer to the above description. for confirmation and then the RUN key 7.3 Function Parameter Group of Input Terminal of F02 Group The standard EM730 series inverter is equipped with five multi-function digital input 171