3-4 Operation Procedure (Example: Factory Default) Setting Functions •Switch the method of the RUN command. (Digital Operator → Control terminal block) •To switch the method of the RUN command from the Digital Operator (factory default) to the control terminal block, you need to change the frequency reference selection (A001) from the Digital Operator (02) to the terminal (01). 1. Display the extended function mode (as "A---"). 3 ak-k-k- •To display "A---", follow the indication method described in "Displaying the Monitor Mode, Basic Function Mode, and Extended Function Mode" (page 3-10)".
•By default, the RUN command LED indicator will light up as the RUN command source is set to the Digital Operator. Operation Press . 2. The code of the extended function mode is displayed (as "A001"). ak0k0k1 Press . ("A002" is displayed.) ak0k0k2 Press . 3. The setting of the extended function mode is displayed (setting in "A002"). •"02 (Digital Operator)" (default setting) is displayed in the RUN command source (A002). •The PROGRAM (PRG) LED indicator lights up while the extended function mode setting is displayed. 0k2 Press . (Continued to the next page) 3-12