Chapter 2: Server Installation Figure 2-5. Accessing the Inside of the System (Rack Confi guration shown) 2-6 Checking the Drive Bay Setup Next, you should check to make sure the peripheral drives and the SCSI/SATA drives and backplane have been properly installed and all connections have been made. 1. Accessing the drive bays All drives can be accessed from the front of the server. For servicing the CD- ROM, IDE hard drives and fl oppy drives, you will need to remove the top/left chassis cover. The SCSI disk drives can be installed and removed from the front of the chassis without removing any chassis covers. 2.
Installing components into the 5.25" drive bays To install components into the 5.25" drive bays, you must fi rst remove the top/ left chassis cover as described in the previous section. Refer to Chapter 6 for details. 3. Installing CD-ROM and fl oppy disk drives Refer to Chapter 6 if you need to reinstall a CD-ROM and/or fl oppy disk drive to the system. 2-9