Chapter 3: System Interface Power Fail: Indicates a power supply module has failed. This should be accompanied by an audible alarm. A backup power supply module will take the load and keep the system running but the failed module will need to be replaced. Refer to Chapter 6 for details on replacing the power supply. This LED should be off when the system is operating normally. 3-4 Drive Carrier LEDs SATA Drives (4021M-T2R+) Green: Each Serial ATA drive carrier has a green LED. When illuminated, this green LED (on the front of the SATA drive carrier) indicates drive activity. A connection to the SATA backplane enables this LED to blink on and off when that particular drive is being accessed.
Please refer to Chapter 6 for instructions on replacing failed SATA drives. Red: The red LED to indicate an SATA drive failure. If one of the SATA drives fail, you should be notifi ed by your system management software. Please refer to Chapter 6 for instructions on replacing failed SATA drives. SCSI Drives (4021M-82R+) Each SCSI drive carrier has two LEDs. Green: When illuminated, the green LED on the front of the SCSI drive car- rier indicates drive activity. A connection to the SCSI SCA backplane enables this LED to blink on and off when that particular drive is being accessed. Red: The SAF-TE compliant backplane activates the red LED to indicate a drive failure.
If one of the SCSI drives fail, you should be notifi ed by your system management software. Please refer to Chapter 6 for instructions on replacing failed SCSI drives. 3-3