Supermicro 4021M-T2R+ / 4021M-82R+ — Supermicro 4021M-T2R+ / 4021M-82R+ Server User & Service Manual PDF

Chapter 5: Advanced Serverboard Setup Power Fail Alarm Reset Header Connect JAR to the alarm reset but- ton on your chassis (if available) or to a microswitch to allow you to turn off the alarm that sounds when a power supply module fails. See the table on the right for pin defi nitions. Compact Flash Power Header A Compact Flash Card Power header is located at JWF1. For the Compact Flash Card to work properly, you will fi rst need to connect the device's power cable to JWF1 and correctly set the Compact Flash Jumper (JCF1).

SGPIO SGPIO1 and SGPIO2 (Serial General Purpose Input/Output) provide a bus between the SATA controller and the SATA drive backplane to provide SATA enclosure management func- tions. Connect the appropriate cables from the backplane to the SGPIO1 and SGPIO2 header(s) to utilize Note: NC indicates no connection. SATA management functions on your system. 5-19 Alarm Reset Header Pin Defi nitions (JAR) Pin# Defi nition 1 Ground 2 Reset Signal Compact Flash Power Header Pin Defi nitions (JWF1) Pin# Defi nition 1 +5V 2 Ground 3 Signal SGPIO Header Pin Defi nitions (SGPIO1, SGPIO2) Pin# Defi nition Pin # Defi nition 1 NC 2 NC 3 Ground 4 Data 5 Load 6 Ground 7 NC 8 NC