AS4021M-T2R+/4021M-82R+ User's Manual 6-3 System Fans Three 8-cm chassis fans (located in the center of the chassis) provide cooling airfl ow while two 8-cm exhaust fans expel hot air from the chassis. The chassis is also fi tted with an air shroud to concentrate the fl ow of cooling air over the areas of highest generated heat. The fans should all be connected to headers on the serverboard (see Chapter 5). Each power supply module also has a cooling fan. Fan Failure Under normal operation, all three chassis fans, both exhaust fans and the power supply fans run continuously. The chassis fans and the exhaust fans are hot-swap- pable and can be replaced without powering down the system.
Replacing Chassis Fans 1. Identifying the failed fan To locate and replace a failed chassis fan, begin by removing the top/left chassis cover (see Chapter 2 for details on removing the cover). Locate the fan that has stopped working. 2. Removing a hot-plug fan housing Depress the locking tab on the failed fan: on a chassis fan, puch the tab on the side of the housing inward, on the exhaust fan push down on the colored tab. With the tab depressed, pull the unit straight out (see Figure 6-3). The wiring for these fans has been designed to detach automatically. 3. Installing a new system fan Replace the failed fan with an identical one (see page 1-1 for part numbers).
Install it in the same position and orientation as the one you removed; it should click into place when fully inserted. Check that the fan is working then replace the top/left side chassis panel. Removing the air shroud Under most circumstances you will not need to remove the air shroud to perform any service on the system. However, if you wish to temporarily remove it (the air shroud should always be in place when the system is operating), please follow this procedure. Begin by depressing the tabs at the front and rear of the shroud to unlock it, then lift it up and out of the chassis (see Figure 6-4).
To reinstall, simply position the air shroud in its proper place and push it in until you hear it click. 6-4