AS4021M-T2R+/4021M-82R+ User's Manual 6-4 Drive Bay Installation SATA and SCSI Drives A total of six SATA or eight SCSI drives may be housed in the SC745TQ-R800/ SC745S2-R800/ chassis. For SATA, the drive IDs are preconfi gured as 0 through 5 in order from bottom to top (or from left to right if rackmounted). For SCSI, the drive IDs are preconfi gured as 0 through 3 (channel A) and 4 through 7 (channel B) in order from bottom to top (or from left to right if rackmounted). A bezel covers the drive area but does not need to be removed to access the drives; simply swing open the bezel.
If you wish to remove the bezel piece, push on the three tabs on the inside of the left lip of the front chassis cover. Then slightly swing out the same (left) side of the cover - about Ѕ inch only. Remove by pushing on the open side of the cover to remove it from the chassis (do not try to swing or pull it straight out after opening the left side). airfl ow. ! Regardless of how many SATA/SCSI drives are installed, all drive carriers must remain in the drive bays to promote proper 1. Installing/removing hot-swap SATA/SCSI drives The SATA/SCSI drive carriers are all easily accessible at the front of the chassis.
These drives are hot-swappable, meaning they can be removed and installed with- out powering down the system. To remove a carrier, fi rst open the front bezel then push the release button located beside the drive LEDs. Swing the handle fully out and then use it to pull the unit straight out. Note: Your operating system must have RAID support to enable the hot-swap capability of the SATA/SCSI drives. 2. Mounting a SATA/SCSI drive in a drive carrier The SATA/SCSI drives are mounted in drive carriers to simplify their installation and removal from the chassis. These carriers also work to promote proper airfl ow for the system.
For this reason, even carriers without SATA/SCSI drives must remain in the server. If you need to add a new SATA/SCSI drive, insert the drive into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier. Secure the drive to the carrier with four screws (see Figure 6-6). 6-6