— Supermicro SuperWorkstation 5046A-X User's Manual (1.0a)

Chapter 2: Installation Installing the System into the Rack You should now have rails attached to both the chassis and the rack unit. The next step is to install the system into the rack. You should have two brackets in the rack mount kit. Install these fi rst keeping in mind that they are left/right specifi c (marked with "L" and "R"). Then, line up the rear of the chassis rails with the front of the rack rails. Slide the chassis rails into the rack rails, keeping the pressure even on both sides (you may have to depress the locking tabs when inserting). When the system has been pushed completely into the rack, you should hear the locking tabs "click".

Finish by inserting and tightening the thumbscrews that hold the front of the chassis to the rack (see Figure 2-4). Figure 2-4. Installing the System into a Rack 2-7