— Supermicro SuperWorkstation 5046A-X User's Manual (1.0a)

Chapter 5: Advanced Serverboard Setup 5-5 Processor and Heatsink Installation ! When handling the processor package, avoid placing direct pressure on the label area of the fan. Notes: Always connect the power cord last and always remove it before adding, re- 1. moving or changing any hardware components. Make sure that you install the processor into the CPU socket before you install the CPU heatsink. Intel's boxed processor package contains the CPU fan and heatsink assem- 2. bly. If you buy a CPU separately, make sure that you use only Intel-certifi ed multi-directional heatsink and fan. Make sure to install the motherboard into the chassis before you install the 3.

CPU heatsink and heatsink fans. When purchasing an LGA 1366 processor or when receiving a motherboard 4. with an LGA 1366 processor pre-installed, make sure that the CPU plastic cap is in place, and none of the CPU pins are bent; otherwise, contact the retailer immediately. Refer to the Supermicro web site for more details on CPU support. 5. Installing an LGA 1366 Processor Press the socket clip to release 1. the load plate, which covers the CPU socket, from its locking position. Socket Clip Load Plate Gently lift the socket clip to 2. open the load plate. Plastic Cap Hold the plastic cap at its north 3. and south center edges to re- move it from the CPU socket.

Hold the north & south edges of the plastic cap to remove it 5-5