S uper W orkstation 5046A-X User's Manual 5-12 Floppy and SATA Ports SATA Ports Six Serial ATA (SATA) ports (I-SATA 0~5) are located on the motherboard to provide serial link connections. Se- rial Link connections provide faster data transmission than those of the traditional Parallel ATA. These SATA ports are supported by the Intel ICH10R Chip (South Bridge). See the table on the right for pin defi nitions. Floppy Connector The fl oppy connector is located be- tween the COM port and FireWire headers on the motherboard. See the table on the right for pin defi nitions. Note the following when connecting the fl oppy cable: The fl oppy disk drive cable has seven twisted wires.
A red mark on a wire typically des- ignates the location of pin 1. A single fl oppy disk drive ribbon cable has 34 wires and two con- nectors to provide for two fl oppy disk drives. The connector with twisted wires always connects to drive A, and the connector that does not have twisted wires al- ways connects to drive B.
5-24 SATA Port Pin Defi nitions (I-SATA0 ~ I-SATA5) Pin # Defi nition 1 Ground 2 TXP 3 TXN 4 Ground 5 RXN 6 RXP 7 Ground Floppy Drive Connector Pin Defi nitions (Floppy) Pin# Defi nition Pin # Defi nition 1 Ground 2 FDHDIN 3 Ground 4 Reserved 5 Key 6 FDEDIN 7 Ground 8 Index 9 Ground 10 Motor Enable 11 Ground 12 Drive Select B 13 Ground 14 Drive Select B 15 Ground 16 Motor Enable 17 Ground 18 DIR 19 Ground 20 STEP 21 Ground 22 Write Data 23 Ground 24 Write Gate 25 Ground 26 Track 00 27 Ground 28 Write Protect 29 Ground 30 Read Data 31 Ground 32 Side 1 Select 33 Ground 34 Diskette