H8QG6/i+-F Serverboard User's Manual 2. Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM3A and CPU1/ DIMM4A, etc. Always install in groups of four and in the numerical order of the DIMM slots. See support information below. 3. Gently press down on the memory module until it snaps into place. 4. With four DIMMs installed, repeat step 2 to populate the CPU2 DIMM slots. Always install four DIMMs to both CPU DIMM slots for more effi cient operation. Note: Memory modules of 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size are supported. It is highly recommended that you remove the power cord from the system before installing or changing memory modules.
Please refer to our web site for memory that has been tested on the H8QG6/i+-F serverboard. The H8QG6/i+-F serverboard supports thirty-two (32) single/dual/tri/quad-channel, DDR3-1600/1333/1066 Mhz SDRAM memory modules. Memory Support Populating four adjacent slots at a time with memory modules of the same size and type will result in interleaved (128-bit) memory, which is faster than non-interleaved (64-bit) memory. Maximum Memory The H8QG6/i+-F serverboard supports a maximum memory of up to 256 GB of ECC/Non-ECC UDIMM or up to 1 TB of ECC RDIMM SDRAM. Figure 2-1. DIMM Installation To Install: Insert module vertically and press down until it snaps into place.
Pay attention to the alignment notch at the bottom. Notch Notch Front View To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot. Note: Notch should align with the receptive key point on the slot. Release Tab Release Tab Top View of DDR3 Slot 2-8