Chapter 2: Installation IPMI LED The serverboard contains an IPMI LED (DP1) located near the corner above the PCI-E slots. When this LED is lit, it means a connection is active for the built-in IPMI on the serverboard. Note: This LED is not installed on non- IPMI boards. UID LED (LE1) A rear UID LED Indicator, located at LE1, works in conjunction with the rear UID switch to provide easy identifi cation for a unit that might be in need of service. Refer to Page 2-19 for further UID details. 2-11 SAS and SATA Drive Connections SATA Ports There are no jumpers to configure the SATA ports, which are designated SATA0 through SATA5. See the table on the right for pin defi nitions.
SAS Ports There are eight SAS ports included on the H8QG6+-F motherboard. See the table on the right for pin defi nitions. enable the SAS controller. Note: JPS1 must be set correctly to 2-25 IPMI LED (DP1) State System Status On Active connection Off No connection SATA Ports Pin Defi nitions (SATA0-SATA5) Pin# Defi nition 1 Ground 2 TXP 3 TXN 4 Ground 5 RXN 6 RXP 7 Ground SAS Ports Pin Defi nitions (SAS0 ~ SAS7) Pin# Defi nition Pin# Defi nition 1 Ground 2 TXP 3 TXN 4 Ground 5 RXN 6 RXP 7 Ground