Supermicro H8QG6+-F / H8QGi+-F — Supermicro H8QG6+-F / H8QGi+-F Serverboard User Manual PDF

Chapter 4: BIOS This option specifi es the base I/O port address and Interrupt Request address of serial port 2. Select "Disabled" to prevent the serial port from accessing any system resources. When this option is set to "Disabled", the serial port physically becomes unavailable. Select "2F8/IRQ3" to allow the serial port to use 2F8 as its I/O port address and IRQ 3 for the interrupt address. Options include Disabled, 2F8/IRQ3 , 3E8/IRQ4 and 2F8/IRQ3. Serial 2 Address Remote Access Confi guration Remote Access Use this option to Enable or Disable Remote Access in your system. If enabled, the settings below will appear. Use this setting to select the serial port for console redirection.

Options include COM1, COM2 or COM3 . The displayed base address and IRQ for the serial port changes to refl ect the selection you make. Serial Port Number Note: Make sure the selected port is enabled. Selects the serial port settings to use. Options are (115200 8, n, 1) , (57600 8, n, 1), (38400 8, n, 1), (19200 8, n, 1) and (09600 8, n, 1). Serial Port Mode Flow Control Selects the fl ow control to be used for console redirection. Options are None, Hardware and Software. Redirection After BIOS POST Options are Disable (no redirection after BIOS POST), Boot Loader (redirection during POST and during boot loader) and Always (redirection always active).

Note that some OS's may not work with this set to Always. Terminal Type Selects the type of the target terminal. Options are ANSI , VT100 and VT-UTF8. VT-UTF8 Combo Key Support Allows you to Enable or Disable VT-UTF8 combination key support for ANSI/ VT100 terminals. 4-9