Automotive Module Series up to 52 MHz to 50 MHz of SPI interface at master mode (Table 4). 4. Updated the information of USB serial driver (Table 4). 5. Modified the information of transmitting power (Table 4). 6. Updated the DL/UL transmitting rate of LTE-FDD and LTE-TDD on AG568N-CN and AG568N-EU (Table 4). 7. Updated the way of firmware grade from DFOTA to FOTA (Table 4). 8. Added the max. output current of VDD_EXT (Table 6). 9. Updated the description and comment of USB_VBUS. (Table 6) 10. Updated the chapter “USB Application with USB Remote Wakeup Function” to “USB Application without USB Suspend Function” (Chapter 3.2.1.1). 11.
Updated the turn-off time by driving PWRKEY low (Chapter 3.6.1) 12. Updated the reset time by driving RESET_N low (Chapter 3.7). 13. Updated the R3 in the reference circuit of USB application from “NM_0R” to “0R” (Tabel 15). 14. Deleted the simple block diagram for Ethernet application (Chapter 4.12&4.13) 15. Updated the information of Tx power (Chapter 5.1.2). 16. Updated the information of Rx sensitivity (Chapter 5.1.3). 17. Added the conditions and typical value of power consumption on AG568N-CN and added the conditions of power consumption on AG568N-EU (Table 51&52). 1. Updated the information of USB serial driver Cathy CHEN/ Kiasher WANG/ Pepe HU (Table 4). 2.
Updated the information of receiving sensitivity 1.0.5 2022-08-30 (Chapter 5.1.3). 3. Deleted the information of GNSS power consumption. 1.0.6 2023-01-19 Cathy CHEN/ Jason FAN 1. Updated the frequency bands of AG568N-NA and AG568N-ROW. 2. Updated the baud rates of Debug UART (Table 4 & Table 12). AG568N_Series_QuecOpen_Hardware_Design 5 / 135