4-2 Function Mode 4-2 Function Mode Output Frequency Setting/Monitor •Set the Inverter output frequency. •With frequency reference selection A001 set to 02, you can set the output frequency with F001. For other methods, refer to the [A001] section in "Frequency Reference Selection" (page 4-10). (If A001 is set other than to "02", F001 functions as the frequency reference monitor.) •If a frequency is set in F001, the same value is automatically set in multi-step speed reference 0 (A020). To set the 2nd/3rd control, use the 2nd multi-step speed reference 0 (A220)/3rd multi-step speed reference 0 (A320) or use F001 with the SET/SET3 terminal turned on.
To set using the SET/SET3 terminal, allocate 08 (SET)/17 (SET3) to the desired multi-function input. •When this monitor is used to display a target value of the PID function, the monitor value is displayed as a percentage (%). (100% = Max. frequency) 4 Functions * To switch to the 2nd/3rd control, allocate 08 (SET)/17 (SET3) to the desired multi-function input and then turn it on. Acceleration/Deceleration Time •Set an acceleration/deceleration time for the motor. For a slow transition, set to a large value, and for a fast transition, set to a small one. 4-8 Parameter No. Function name Data Default setting Unit F001 Output frequency setting/monitor 0.0/Starting frequency to 1st/2nd/3rd max.
frequency Hz A020 Multi-step speed reference 0 6.0 A220 *2nd multi-step speed reference 0 A320 *3rd multi-step speed reference 0 Related functions A001, A020, A220, A320, C001 to C008 Parameter No. Function name Data Default setting Unit F002 Acceleration time 1 0.01 to 3600 30.00 s F202 *2nd acceleration time 1 F302 *3rd acceleration time 1 F003 Deceleration time 1 F203 *2nd deceleration time 1 F303 *3rd deceleration time 1