3-6 Parameter Transition „ Direct Code Specification and Selection • The codes can be specified or selected by directly entering each digit of the codes or data, as well as by scrolling the codes of the monitor, basic function, and extended function modes. • Below is an example where monitor mode code "d001" is changed to extended function code "A029". 1. Display the monitor mode code. ("d001" is displayed.) 3 dk0k0k1 Operation Press and simultaneously. *1 *2 *3 2. Change the extended function mode. • "d" of the 4th digit on the left starts to blink. dk0k0k1 Press (2 times). ("A001" is displayed.) *3 • "A" blinks. • Press the Enter key to fix the blinking digit. ak0k0k1 Press .
*2 ("A" is entered.) (Continued to the next page) 3-16