omron — Connecting a Noise Filter

7.4 Installing Peripheral Devices TERMS TERMS TERMS Radiated noise: Electromagnetic waves radiated from the drive and cables create noise throughout the radio bandwidth that can affect devices. Induced noise: Noise generated by electromagnetic induction can affect the signal line and may cause the controller to malfunction. Preventing Induced Noise Use a noise filter on the output side or use shielded cables. Lay the cables at least 30 cm away from the signal line to prevent induced noise.

Figure 7.8 A C B R/L1 MCCB S/L2 U/T1 V/T2 D T/L3 W/T3 G E F A – Power supply E – Separate at least 30 cm B – Drive F – Controller C – Shielded motor cable G – Signal line D – Motor H – Figure 7.8 Preventing Induced Noise 270 OYMC TOEP C71060622-01-OY V1000 User Manual