omron — D.5 User Setting Table

D.5 User Setting Table Standards Compliance D OYMC TOEP C71060622-01-OY V1000 User Manual 425 No. Name User Setting L3-02 Stall Prevention Level during Accel. L3-03 Stall Prevention Limit during Accel.

L3-04 Stall Prevention Selection during Deceleration L3-05 Stall Prevention Selection during Run L3-06 Stall Prevention Level during Run L3-11 OV Suppression Function Selection L3-17 Overvoltage Suppression and Deceleration Stall (Desired DC Bus Voltage during Motor Stall) L3-20 Main Power Circuit Voltage Adjustment Gain L3-21 Accel/Decel Rate Calculation Gain L3-22 Deceleration Time at Stall Prevention during Acceleration L3-23 Automatic Reduction Selection for Stall Prevention during Run L3-24 Motor Acceleration Time for Inertia Calculations L3-25 Load Inertia Ratio L4-01 Speed Agreement Detection Level L4-02 Speed Agreement Detection Width L4-03 Speed Agreement Detection Level (+/-) L4-04 Speed Agreement Detection Width (+/-) L4-05 Frequency Reference Loss Detection Selection No.

Name User Setting L4-06 Frequency Reference at Reference Loss L4-07 Frequency Detection Conditions L5-01 Number of Auto Restart Attempts L5-02 Auto Restart Operation Selection L5-04 Fault Reset Interval Time L5-05 Fault Reset Operation Selection L6-01 Torque Detection Selection 1 L6-02 Torque Detection Level 1 L6-03 Torque Detection Time 1 L6-04 Torque Detection Selection 2 L6-05 Torque Detection Level 2 L6-06 Torque Detection Time 2 L6-08 Mechanical Weakening Detection Operation L6-09 Mechanical Weakening Detection Speed Level L6-10 Mechanical Weakening Detection Time L6-11 Mechanical Weakening Detection Start Time L7-01 Forward Torque Limit L7-02 Reverse Torque Limit L7-03 Forward Regenerative Torque Limit L7-04 Reverse Regenerative Torque Limit L7-06 Torque Limit Integral Time Constant L7-07 Torque Limit Control Method Selection during Accel/Decel