Mechanical steering column lock in vehicles with an ignition lock Remove the key from the ignition when the vehi- cle is stationary and the steering column will be locked. Slightly turn the steering wheel until the steering lock clicks into place. must always actively apply steering to the vehi- cle, as the reverse steering assist function will not steer the vehicle. NOTICE To unlock the steering column lock, insert the ve- hicle key into the ignition and turn the steering wheel slightly to release the steering column lock. Hold the steering wheel in this position and switch on the ignition.
To prevent the steering wheel from locking and to ensure that the turn signals, horn, wipers, and window washer are working properly when tow- ing the vehicle, keep the ignition switch on. Electromechanical steering system The power steering provided by the electrome- chanical steering system automatically adjusts to the vehicle speed, steering torque, and steering angle of the wheels. The electromechanical steering only functions when the engine is run- ning. Troubleshooting Steering fault The warning lamp flashes red. There is a fault in the electronic steering lock. – Do not drive on! Seek expert assistance.
You will need considerably more strength than normal to steer the vehicle if the power steering is reduced or has failed completely. – If the warning lamp lights up red, the steering may be stiff because the electromechanical steering has failed. – If the warning lamp flashes red, it is not possi- ble to unlock the steering column. Steering fault The indicator lamp lights up or flashes yellow. Reverse steering assist function The reverse steering assist function can provide the driver with reverse steering assistance in emergency situations, thus stabilizing the vehi- cle → . The steering is harder or more sensitive than usual.
If the power steering is not working, the steer- ability of the vehicle will be significantly re- duced due to a stiff steering wheel. This can lead to a loss of vehicle control, accidents, seri- ous injuries and death. WARNING The indicator lamp lights up continuously : – Restart the engine and drive a short distance slowly. – If the warning lamp stays lit, the system should be checked by a suitably qualified workshop. Volkswagen recommends using a Volkswagen dealership. ● The power steering system only works when the engine is running. ● Never allow the vehicle to roll if the engine is switched off. The indicator lamp flashes: – Turn the steering wheel to and fro.
● Never remove the key from the ignition lock while the vehicle is in motion. Otherwise, the steering lock may engage and you will no longer be able to steer the vehicle. This can result in accidents and serious or even fatal injuries. – Switch the ignition off and then on again. – Observe the messages on the instrument clus- ter display. – Do not continue your journey if the indicator lamp still flashes after the ignition is switched on. Seek expert assistance. WARNING In conjunction with ESC, the reverse steering assist function provides driver support during critical steering situations. However, the driver 182.5C1.TRO.74 Driving 109