Vehicle dimensions The data in the table applies to the basic model with basic equipment. The specified values can vary due to additional equipment, different model versions, and also for special vehicles and vehicles that have been manufactured for other countries. a) The specified values can vary due to different wheel rim and tyre sizes. ● Be cautious when encountering lane protru- sions, ramps, curbs, and similar obstacles. Fail- ure to do so may damage the bottom compo- nents of the vehicle, such as bumpers, spoilers, travel system, engine, and the exhaust system. ● Always drive carefully and be mindful of raised curbs or short posts in parking lots.
These can easily damage the bumper and other vehicle parts when parking. NOTICE Vehicle performance parameter The values listed in the table below apply to vehi- cles with a properly run-in engine, driving under normal road and weather conditions. er. This depends on aspects such as the road sur- face, weather conditions and engine power. The values apply to a moving vehicle and not to driv- ing off from standstill. The vehicle performance parameters provided in this manual are determined without any addi- tional equipment that may affect the vehicle's performance, such as roof carriers or fenders.
The number of metres in height gained over a distance of 100 m (gradient) will be given as a percentage or degree value (100% = 45 degrees). Gradient angle The gradient angle is an indication of the vehi- cle’s gradeability and corresponds to the gradient that the vehicle can drive up under its own pow- 182.5C1.TRO.74 Technical data 225 Length 4,624 mm Width 1,841 mm Height (unladen weight) 1624/1633/1644 mm Wheelbase 2,730 mm Minimum turning diametera) 10.8 m Front wheelbasea) 1,572 mm Rear wheelbasea) 1,544 mm Ground clearance at allowable gross weight 160 mm