Seat belt protection airbags. Therefore, traffic laws in most countries require drivers and passengers to wear seat belts while driving. Please refer to at the start of the chapter on page 30. Even if a vehicle is equipped with airbags, all drivers and passengers are required to wear seat belts for the following reasons: front-seat front airbags, for example, trigger in a serious frontal collision.
However, when the vehicle has a mild frontal collision, a mild side collision, a rear colli- sion, a rollover or an accident that does not ex- ceed the airbag trigger limit set in the control unit, the system will not trigger the front front airbag, and only the seat belt provides protection for the occupants. Therefore, always fasten your seat belt before starting to drive, and remind all occupants to fas- ten their seat belts! Fig. 24 Drivers who wear safety belts properly dur- ing emergency braking are effectively protected Information for using seat belts It's important to wear your seat belt properly!
Properly worn seat belts not only keep the driver and passenger in the correct position where they are less likely to be injured and absorb most of the kinetic energy of a collision, they also prevent out-of-control motion that could result in serious injury to the driver and passenger. In addition, properly worn seat belts reduce the risk of being thrown from the vehicle → Fig. 24 . Please refer to at the start of the chapter on page 30. Checklist Information for using seat belts → : Check the condition of all seat belts regular- ly. Seat belts must be kept clean. Do not let foreign objects such as liquids touch the seat belt and seat belt latch, or en- ter the seat belt latch.
Do not damage the seat belt by clamping it in position. For example, be careful not to clamp the seat belt when closing the car door. Do not remove, modify or repair seat belts or any parts of seat belt fixtures yourself. Always fasten your seat belt before you start driving and wear it throughout the journey. The seat belt's primary function is to absorb most of the kinetic energy from a crash. The front end of the vehicle and other passive safety devices (e.g., airbag systems) are also designed to absorb collision kinetic energy.
These safety devices, in conjunction with seat belts, further reduce the force acting on the passenger's body, effectively protecting the driver and passenger from acci- dents or minimizing injuries and deaths. Although this example describes a head-on colli- sion, proper seat belts can also protect drivers and passengers in other types of accidents and reduce the risk of injury or death. Therefore, ev- eryone must wear a seat belt before driving -- even if they are “driving nearby” -- and urge all occupants to fasten their seat belts.
Twisted seat belt If it is difficult to pull the seat belt out of the seat belt guide, the seat belt may return to the side panels too fast, causing the seat belt to become twisted. Traffic accident statistics show that the correct wearing of seat belts is an effective means to re- duce accident casualty rate and improve occu- pant survival rate. At the same time, it can also make full use of the auxiliary protection effect of – Grab the seat belt latch and slowly pull the seat belt out. 182.5C1.TRO.74 – Smooth the harness with your hands and slow- ly guide it back into the side trim. Safety precautions 33